KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-750RT
This warranty is null & void, if you fail to register the warranty with
KisanKraft by sending the KisanKraft Copy with dealer’s stamp.
: +91.80. 6835 7800
Page 18 of 36
5.
Prevent mini tiller from falling down when tilling.
6.
Never install mini tiller with rotary blades work on sand or stone to avoid damaging
blades.
7.
After tilling, pay attention to clear away dirtiness on the mini tiller: mud, grass and
oil stain.
8.
Frequently wash the sponge in the air filter and change oil more often.
MAINTENANCE
Due to rotary situation, abrasion and load change of mini tiller, bolts will become loose,
and parts will be
worn during the work. These changes will destroy the proper working
state of mini tiller, create abnormal fitting clearance, degrade output of diesel engine,
increase oil consumption, lead to the maladjustment of spare parts, increase malfunction
of mini tiller. All these will seriously affect the working efficiency of mini tiller. To decrease
the frequency of the above-mentioned accidents, prevention of maintenance work must be
done strictly and regularly to keep the mini tiller in a good technical state and prolong its
life.
I Running-in of
mini tiller:
1.
As for running-in of mini tiller, please refer to its instruction.
2.
If mini tiller is new or is just heavy repair, it should work without load for one hour.
After the mini tiller works with light load for five hours, all oil in gear box and
crankcase of diesel engine should be drained immediately. Afterwards, you
should refuel adequate clean oil, run the mini tiller at idle speed for 3 to 5 minutes
to wash it , then drain oil completely. Please refuel oil and carry out running-in
for 4 hours according to the fourth procedure of chapter3. By doing so, the mini
tiller can work in normal condition.
Ⅱ
Technical maintenance of mini tiller
A. Every-time maintenance (before and after work ):
1.
Listen and check if there is malfunction of every part (such as abnormal noise,
overheat, loose screw and so on).
2.
Check if there is oil leakage from diesel engine, gear box and running gear.
3.
Check if the oil level of diesel engine and gear box is between the upper and
lower limit of dipstick.
4.
Clean the whole machine and spare parts which are with mud, grass and oil
stain regularly.
5.
Do daily record.
B. Primary maintenance (per 150 hours)
6.
Carry out maintenance work based on all contents of every- time
maintenance.
7.
Wash gear box, running gearbox and change lube oil.
8.
Check and adjust clutch, shift system and reverse gear system.
C. Secondary maintenance (per 800 hours)
9.
Carry out maintenance work based on all contents of primary maintenance.
