KisanKraft
®
INTERCULTIVATOR
KK-IC-320P
: +91.80.
6835 7800
Page 11 of 32
PRODUCT OVERVIEW
1
Handle frame
2
Flameout switch
3
Oil switch
4
Gasoline engine
5
Bumper
6
Walking round Assy
7
Rotary parts
8
Fender parts
9
Output clutch handle
10
Clutch handle
INSTALLATION METHOD
Assembly after unpacking:
1.1. Walking round
Fix the body of Inter-cultivator , install wheels on both sides of hexagonal shaft and fix it
by clip B and Pin.
1.2 Armrest frame
Install Armrest: Put the bolt of armrest plate into the hole on rotary plate, and then lock
those tight with press gasket, wave washer and nut.
1.3 Fix handle cover on the rotary plate with Bolt M6x12.
1.4 Checking the Inter-cultivator attached components if it exists lack, then go for next
step following this manual.
OPERATION INTRODUCTION
Before sending the Inter-cultivator out of factory, adjusting and debugging is done, for
comfortable and easier using, the user should inspect and adjust it again.
1. Daily Checking
1.1 Check all the bolts in the connecting part ensure all of them are tightening.
1.2 Checking the handles (throttle, Clutch and gear shifting lever), make them flexible
and in the correct position.
1.3 Put the shift lever in the neutral gear place.
1.4 Add oil:
•
Add lube oil (SAE10W-30) to crankcase as Photo III shows.
