KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 29 of 80
1.
The up and down debugging for the handle bar connection
a)
Unscrew the Locked handle of the handle bar connection, and make the terminal
tooth between the handle bar connection and the handle bar base separated.
b)
Select the best position for the handle bar connection according to your height
and comfort.
c)
Then spin the handle to make the terminal teeth between the handle bar
connection and handle bar base engage well with each other.
2.
The left and right debugging for the handle bar connection.
a)
Unscrew the locknut handle of the handle bar base and the upper and lower
terminal teeth.
b)
Spin the handle bar left or right to the desired position.
c)
Then screw the locknut handle to make the higher and lower terminal teeth of the
handle bar base engage well with each other.
Troubleshooting of Clutch:
NOTE: Please do not dismantle the clutch assembly yourself. You should contact our
dealers for such repairs
Symptom
Cause
Remedy
Clutch fails
Failure of the clutch handle
Repair or replace the clutch
handle
Damage of the clutch Cables
Replace the clutch cables
Fork not in the right position
Re-adjust the cable or replace
the fork
Welding points between fork
shaft and arm base break off
Repair or replace the clutch
cables
Fork pin is bent or broken
Replace the fork pin
Malfunction of the friction piece Replace the friction piece
Malfunction of spring
Replace the spring
The friction piece fails to touch
the bearing face of the clutch
cover
Add some adjustment pads to
the back of the bearing
Bearing is burnt in the clutch
Replace
the
bearing
Pay
attention to refilling engine oil
into the gear-box
Skidding/Slipping
(after loosening
the clutch, the
diesel
engine
runs
normally,
but
the
main
shaft
of
the
The spring does not function
due to tiredness
Replace the spring
Fork
shaft’s failure to turn
around freely makes the fork
fail to reset completely
Clean
the
combined
face
between positioning shaft and
pushing plate to make the fork
move freely.
Cable adjustment is not right
Re-adjust the clutch Cables.