5
INSTALLATION
INSTALLATION
Install the Shade
If You Have a Cassette Shade with an attached Battery Wand
■
Attach the battery wand clip to the back of the cassette approximately 10” from the motor side.
➤
Place the bottom of the clip into the lip, squeeze to compress the clip then rotate it up and hook it into the top channel.
■
Angle the cassette and bring it forward to catch the front lip of the bracket.
■
Push the cassette up and back to snap it into the lower lip on the bracket.
Connect the Power Source
NOTE:
When power is connected to the motor, a GREEN LED inside the manual control button housing will flash twice to
indicate the shade is ready for operation.
■
Refer to the appropriate page based on your order.
➤
For an attached battery wand, see below.
➤
For a satellite battery pack, see page .6
➤
For an optional DC power supply, see page 7.
➤
For an optional DC power supply with daisy-chain connections, see page 7.
➤
For an optional C-size satellite battery wand or large DC supply, see the instructions that came with the wand.
Plug the Power Cable into the Battery Wand
■
S
nap the battery wand into the battery wand clip on the back of the cassette.
■
Connect the power cable from the motor to the battery wand.
Proceed to “Unpack the Wand and Add to Activation Arm” on page 7.
Squeeze to
Compress
Clip Installed
Correctly
Lower
Lip of
Bracket
Brackets removed for clarity.
Battery Wand
Battery Wand Clip
Power
