9
INSTALLATION
OPERATION
Adjust the Shade Limits (If Necessary)
Adjust Upper Limit
■
Move the shade to the current upper limit position. See “Operate the Shade” on page 9.
■
With the shade stationary, push up on the wand, release, then within
1
⁄
2
a second push and hold the wand up. After
approximately 6 seconds, the shade will buzz and a red LED will flash continuously to indicate the upper limit is ready to be
adjusted.
■
Move the shade up until it stalls at the hard stop, now the limit is set.
To Set The Upper Limit Lower than the Hard Stop Position
■
If you want the limit set lower, lower the shade to the desired upper limit location.
■
With the shade stationary, push up on the wand, release, then within
1
⁄
2
a second push and hold the wand up. After
approximately 6 seconds, the shade will buzz and a red LED will flash continuously to indicate the upper limit is ready to be
adjusted.
■
Push and hold the wand up (approximately 6 seconds), until the shade buzzes, a green LED will flash and the shade jogs down
to indicate the new upper limit has been set.
■
Release the wand.
Adjust Lower Limit
■
Move the shade to the current bottom limit position. For steps to operate the shade, see “Operate the Shade”on page 7.
■
With the shade stationary, pull down on the wand, release, then within ½ a second pull and hold the wand down. After
approximately 6 seconds, the shade will buzz and a red LED will flash continuously to indicate the lower limit is ready to be
adjusted.
■
Move the shade to the desired lower limit location.
■
Pull and hold the wand down (approximately 6 seconds), until the shade buzzes a green LED will flash and shade jogs down to
indicate the new lower limit has been set.
■
Release the wand.
If the shade stalls prior to reaching the bottom limit ordered, please contact Kirsch.
Troubleshooting
Problem
The shades raises or lowers unevenly.
Solution
■
Check that the installation brackets are level and aligned. Shim the brackets, if necessary. Shims are not provided.
Problem
Replace the batteries in the battery wand.
Solution
■
Squeeze the cap latch to release
the cap and remove the cap from the battery wand.
■
Install the batteries according to the instructions on the
battery wand label.
■
Press the cap on until it latches.
NOTE:
Kirsch recommends AA alkaline batteries for use with our
battery-powered shadings. These will provide more than one year of
operation, depending on usage. Lithium and rechargeable batteries are not recommended.
Cap
Latch
Battery
Wand
Squeeze
