11
INSTALLATION
INSTALLATION
■
■
Adjust the moving rail to vertical, if necessary. Work from the front side of the shade.
■
➤
Locate the Phillips screws on the moving rail bracket.
■
➤
To adjust the bottom end of the moving rail to the right, loosen the right screw one-half turn, then tighten the left screw
one-half turn. Repeat until the rail is properly aligned.
■
➤
To adjust the bottom end of the moving rail to the left, loosen the left screw one-half turn, then tighten the right screw
one-half turn. Repeat until the rail is properly aligned.
IMPORTANT:
After making the adjustments, check to be sure both screws are tight on the moving rail bracket.
■
■
Tension the cord.
IMPORTANT:
When the cord is properly tensioned, the moving rails slide easily yet hold their position anywhere along their travel.
■
➤
Slide the cord tensioner along its channel in the headrail until the cord is taut.
■
➤
Fully open and close the fabric stack several times. This evenly distributes tension throughout the shade.
■
➤
If necessary, readjust the cord tensioner by sliding it until the cord is taut. Check to ensure the proper tension. Make any
needed adjustments by sliding the cord tensioner in its channel so that the moving rail slides easily and holds its position
anywhere along its travel.
Proceed to “Valance Attachment” on page 19.
Left Stack
= Tighten
= Loosen
Right Stack