Kirisun PT4208, Service Manual

Page: 13 / 53

PT4208 Service Manual
12
Figure 5.5
5.4 Remove the main board from the Al chassis
1) Remove the screws from the PCB board by a cross
screwdriver;
2) Remove the solder of the antenna terminal with a
soldering iron. Then take off the main board.
Refer to Figure 5.6
Figure 5.6
After the aforesaid disassembly, you can repair and
adjust the radio according to its actual malfunction.
1
2
3
4
5
6
8
9
10
17 18 19 20 21 22
11 12 13
14
15
16
23 24 25
27
28 29 30 31
7
26 32 33 34
35
37
36
Figure 5.7 Exploded View
No. Part No. Description PCS
1 710-420470-R06 Antenna 1
2 201-004208-R07 Channel Selector Knob 1
3 201-004208-R06 Volume Knob 1
4 203-003208-R09 Circlip 2
5 203-007200-R07 Nut for Antenna Socket 1
6 203-000558-R02 Nut for Knob 2
7 201-004208-R09 Light Guide 1
8 201-004208-R01 Front Cabinet 1
9 201-004208-R08 Earphone Jack Cover 1
10 301-25080J-R01 Screw M2.5*8.0 1
11 202-004208-R01 Main Waterproof 1
12 201-004208-R02 Coping 1
13 301-25050J-R01 Screw M2.5*5.0 2
14 202-007200-R07 Rubber Plug 2
15 203-000558-R05 Spring for Battery Latch 1
16 201-004208-R03 Battery Latch 1
17 204-003208-R02 Dust-proof Net for Speaker 1
18 202-004208-R02 Rubber PTT Key 1
19 201-004208-R04 PTT Key 1
20 121-100000-R20 Speaker 1
21 301-20040G-R01 Screw M2.0*4.0 12
22 602-04208X-HXX Main Board 1
23 201-004208-R05 POGO Pin Socket 1
24 203-004208-R02 Earphone Plate 1
25 203-000558-R07 Antenna Socket 1
26 204-004208-R02 Dust-proof Net for MIC 1
27 202-007200-R06 POGO Pin Waterproof 1
28 203-004208-R01 Al Chassis 1
29 301-20080G-R02 Screw M2.0*8.0 2
30 204-007200-R03 Sponge for POGO Pin 1
31 706-0KB70B-R01 Battery 1
32 202-004208-R03 MIC Rubber Waterproof 1
33 120-100000-007 Plastic-packaged Wire 1
34 120-100000-008 Plastic-packaged Wire 1
35
202-003208-R07 Heat Exchange Silicone
Rubber Washer
1
36 204-006500-R02 MIC Socket Guardian 1
37 204-0KB36L-R03 Sponge Cushion 1
Chapter 6 Adjustment
Before test/adjustment, make sure all equipment has
been well connected to the ground!
Before test/adjustment, make sure the antenna output
terminal has been correctly connected to corresponding
equipment or load!
The transmitter output terminal must be terminated with