Kirisun PT4208, Service Manual

Page: 10 / 53

PT4208 Service Manual
9
Chapter 4 Mode Introduction
Mode Introduction
Mode Function How to enter
User Mode For normal use Power ON
Data
Programming
Mode
Used to read and write
frequency data and
other features to and
from the radio
Received commands
from PC. See below for
further information.
PC Test Mode
Tune the radio
parameters by PC
Received commands
from PC. See below for
further information.
PC
Mode
Firmware
Programming
Mode Upgrade the radio
when new features are
released
Press and hold the top
key for over 2 seconds
while turning the radio
power ON, and received
commands from PC
Wired Clone Mode
Used to transfer
programming data
from one radio to
another Press and hold side key 2
for over 2 seconds while
turning the radio power
ON
* User Mode
You can enter User Mode (conventional communication
mode) by turning the radio power ON. Under this mode,
users can use the defined functions of the radio.
* Data Programming Mode
The radio has been set before leaving the factory.
However, due to different requirements of users, the radio’s
operating frequency, channels, CTCSS/DCS, scan, and other
functional parameters should be reprogrammed. Therefore,
Kirisun has specially designed a set of Chinese/English
programming software KSP4208 with friendly interface,
convenient operation and visualized display for setting
functional parameters of the radio.
Steps for setting the functional parameters of the radio by
PC are as follows:
A. Install KSP4208 on the computer.
B. Connect the radio to the serial port of the PC with
the special programming cable. Refer to the figure
below.
Figure 4.1
C. Turn the computer power ON.
D. Turn the radio power ON.
E. Run the KSP4208 programming software by
double clicking on its executive program.
F. Click “Program” in the main menu of KSP4208,
and click “Read from radio” in the pull-down menu
to read parameters of the radio to the computer;
click “Write to radio” in the pull-down menu to
write parameters in the computer to the radio.
G. The following parameters can be set by using
KSP4208 according to requirements of the user:
Radio Information:
Radio Model (model/frequency range), Serial Number,
Embedded Information, MCU Version, Hardware Version,
etc.
Radio Configuration:
(1) Key Assignment: Side Key 1 (Up Key), Side Key 2
(Down Key), and Top Key can be set as long/short key and
the hold time can be defined.
(2) Miscellaneous
1. Wired Clone Mode
2. TOT (Time Out Timer)
3. TOT Reset
4. TOT Pre-alert
5. TOT Re-key time
6. Squelch Level selection
7. Alert Tone
8. Read Data Password
9. Write Data Password
(3) Scan
Scan Function option, Priority Channel, Revert Channel,
Tx Dwell Time, Dropout Delay Time, Lookback Time.
(4) Emergency settings
Channel Parameters
(1) Rx Frequency and Tx Frequency (Step:
2.5KHz/5KHz/6.25KHz)
(2) Rx Signaling and Tx Signaling
a) None
b) CTCSS (60~260Hz @ 0.1Hz step)
c) DCS (-777~777@octal number)
(3) Busy Channel Lockout (BCL)
(4) Beat Shift
(5) Channel Spacing: 25KHz/12.5KHz (Wide/Narrow)
(6) Scan Add/Delete
(7) Tx Power (High/Low)
(8) Clear Tail Tone
(9) CALL1 and CALL2 encode
(10) PTT ID Keyup Telegram, PTT ID Dekey Telegram
DTMF Setting
DTMF Encoder Template
Computer
(RS232 serial port)
Programming
cable
Radio
(Earphone/Program
ming interface)