Kirby Morgan, SuperLite, Band Mask, KMB Band Mask, EXO, SuperMask, SuperFlow, and Rex are all registered trademarks of Kirby Morgan Dive
Systems, Inc. Use of these terms to describe products that are not manufactured by KMDSI is not permitted without written permission from KMDSI.
© Copyright 1970-2016 Kirby Morgan Dive Systems, Inc. All rights reserved. This manual is made available for the express use of owner of this Kirby
Morgan product. No part of this manual may be reproduced, stored in any retrieval system, or transmitted, or used in any form or by any means, whether
graphic, electronic, mechanical, photocopy, or otherwise by technology known or unknown, without the prior written permission of
Kirby Morgan Dive Systems, Inc.
Copyright 2003-2016, Dive Lab® Inc. All rights reserved. InspTrnG 03100
STEP
PROCEDURES
INITIALS
NOTE: On the SL-17A/B, this
procedure will ensure the Neck
Clamp w/Yoke Assembly is prop-
erly adjusted prior to descent.
NOTE: All equipment must be
adjusted properly and functioning
correctly. The Helmet/Mask must
be breathing easily and properly.
a. On SuperLite 17 A/B, ensure the Rear Hinge
Tab is fully engaged on the alignment sleeve.
Using thumb on the bottom of Regulator Body,
and middle finger on Neck Clamp, attempt
to “pop” Neck Clamp w/Yoke Assembly from
bottom rim of Helmet.
b. Diver’s Safety Harness
c. Umbilical Strain Release
d. EGS Hose Quick Disconnect
e. Boots, Gloves, Knife and other accessories.
f. Helmet supply pressure, minimum 115 psig.
8. Check Breathing
Diver:
Check to ensure helmet is breathing properly.
NOTE: All equipment must be adjusted properly
and functioning correctly. The Helmet/Mask
must be breathing easily and properly.
KMDSI highly recommends that a certified KMDSI Repair Technician make all repairs and that only genuine
KMDSI repair and replacement parts be used. Owners of KMDSI products that elect to do their own repairs
and inspections should only do so if they possess the knowledge and experience. All inspections, maintenance,
and repairs should be completed using the appropriate KMDSI Operations and Maintenance Manual(s). Persons
performing repairs should retain all replacement component receipts for additional proof of maintenance history.
Should any questions on procedures, components, or repairs arise, please contact Kirby Morgan Dive Systems, Inc.,
by telephone at (805) 928-7772 or via e-mail at [email protected], or contact Dive Lab, Inc., by telephone at
(850) 235-2715 or via e-mail at [email protected].
NOTE: The Maintenance Log, Appendix 3, of the Operations and Maintenance Manual may be used as a template
to create blank pages to record all the maintenance.
Technician (Print):
Signature:
Date:
Comments:
3
