© Kirami Oy, Finland
Page 2
Instrcution manual: Kirami Micu outside heater for hot tubs
Installation
The locking latch for the heater door must be attached to its palce according the image. Also
make sure that the washers are on their places on the hinges before lifting the door into its
place.
The installation procedure varies between different barrel / tub models. Common to them all is
that you use two rubber hose pieces and hose clamps to fix the heater in its place. Using of the
fixing pieces and installation height varies. In all installation types it is advisable to spray silicon
spray or other lubricant like soap inside the rubber hoses to tighten the hose clamps evenly and
to prevent the hoses from wrinkling.
Tighten the clamps tight enough so that there is no
leakage.
Chimney
You can use a Ø120mm outer diameter acid proof steel chimneys in this heater. The reduced
end of the chimney will fit inside the heater. These chimneys are sold
in 50 and 100cm pieces. There is also a heat protection piece
available length of 100cm. We recommend a chimney kit that has
150cm c 100cm heat prot hat. There are also hats
with spark protection net available.
If you have purchased a chimney kit with the heater. It is supplied in a
separate box and has four parts (see picture right) and it has to be assembled.
Remove the protective film from the thermal protection and place the assembled chimney to
the chimney outlet of the stove.
14/40
12.02.2021
Summary of Contents for Micu
