VISION 2460 OWNER’S GUIDE
3
Arming & disarming
ARMING
CONFIRMATION CHIRPS
NORMAL ARMING
Close all doors and then LOCK by your factory
keyless remote or by SmartKey door handle
touch.
Parking lights may flash, doors will lock,
and the horn/siren will chirp 1 time (if Confirmation
Chirps are ON). The Status LED will light for 5s, dur-
ing which time all triggers are disabled. Then the Sta-
tus LED will start flashing and Ignition, Door, Trunk
and Hood triggers become enabled. The Shock Sensor (and any other
exter-
nal
sensor) is enabled 5s after the LED starts flashing (10s after you Lock).
SENSOR BYPASS ARMING
(2460H does not include a shock sensor)
This procedure lets you temporarily disable
the Shock Sensor (2460B) for a single Arming
session:
1)
With Ignition OFF, press the Program Switch
twice
.
2)
Within 20s, press
LOCK
on the factory remote to Arm.
The system is now Armed in Sensor Bypass Mode, and all triggers are active
except the shock sensor and any other external sensors
. Note that when you
Disarm and then Arm again normally, the shock sensor will be enabled.
(ON by default)
This procedure lets you enable or disable the
Arm/Disarm chirps. (Note that the siren will
still go off when the 2460 is triggered.)
1)
With Ignition OFF, press the Program Switch
once
.
2)
Within 20s, press
LOCK
on the factory remote to Arm.
The confirmation chirp state has now toggled and the system is Armed. Re
-
peat the above procedure to toggle the confirmation chirp state back again.
PROGRAMMABLE
Vehicles without Factory Keyless require an optional remote.
OFF
OFF
LOCK
2 Pushes
1 Push
