12
VISION 2460 INSTALL GUIDE
6-wire main harness
WHT
(–) Door Input
YEL
(–) GWA Output
This input wire detects if a Door (usually one of the two front doors of a truck)
is opened. If opened while the 2460 is Armed, the horn/siren will blast for up
to 30 seconds. Wiring is shown below in
Fig-5
. Door switches must be open-
ciruit and not supplying (–)GND when the Door is closed.
In situations where you need the WHT wire to connect to multiple loca-
tions, adding multiple diodes to the WHT wire can be tedious and prone to
error. We therefore recommend the optional
DSS-6
(1-to-6 splitter) to make
installation faster and error free. When using the DSS-6, please refer to its
product manual instead of
Fig-5
above.
We don’t recommend using the WHT wire for the Back Door of a long
trailer because the WHT/BLK wire, described on page 8, is intended for
that purpose. If do you connect the WHT wire to the Back Door, you can-
not easily disarm with a mere press on factory keyless Unlock.
IMPORTANT!
FIG-5: Door/Trunk wiring
Supplies (–)0v ground (0.7A max., NPN transistor) while the 2460 is Armed.
Shuts off attached devices when the 2460 is disarmed. Connect as shown in
Fig.6
below.
700mA
OPTIONAL
FIG-6: GWA control of LED Scanners
YEL
RED
BLK
YEL
PUR
(+)12V
(+)12V
