10
-26
CK22
* At 760 mmHg pressure (atmospheric).
A higher boiling point is obtained by
using a radiator pressure cap which
permits the development of pressure
within the cooling system.
If cooling water freezes, it can damage
the engine and radiator. It is necessary,
if the ambient temperature falls below
32° F (0° C), to remove cooling water
after operating or to add anti-freeze to
it.
1. There are two types of anti-freeze
available; use the permanent type
(PT) for this engine.
2. Before adding anti-freeze for the first
time, clean the radiator interior by
pouring fresh water and draining it a
few times.
3. The procedure for mixing of water
and anti-freeze differs according to
the make of the anti-freeze and the
ambient temperature, basically it
should be referred to SAE J1034
standard, more specifically also to
SAE J814C.
4. Mix the anti-freeze with water, and
then fill into the radiator.
ANTI-FREEZE
Vol. %
Anti-freeze
40
50
Freezing Point
°C
-24
-37
°F
-12
-34
Boiling Point*
°C
106
108
°F
222
226
The above date represents indus-
try standards that necessitate a
minimum glycol content in the con-
centrated anti-freeze.
When the cooling water level drops
due to evaporation, add water only.
In case of leakage, add anti-freeze
and water in the specified mixing
ratio.
Anti-freeze absorbs moisture. Keep
unused anti-freeze in a tightly
sealed container.
Do not use radiator cleaning agents
when anti-freeze has been added
to the cooling water. (Anti-freeze
contains an anti-corrosive agent,
which will react with the radiator
cleaning agent forming sludge
which will affect the engine parts.)
NOTE
Replace the hoses and clamps.
(See "Checking Radiator Hose and
Clamp" in every 200 hours maintenance.)
REPLACING RADIATOR HOSE
(WATER PIPES)
REPLACING HST OIL LINE
Replace the hoses and clamps.
(See "Checking HST oil line" in every
200 hours maintenance.)
REPLACING FUEL HOSE
Replace the hoses and clamps.
(See "Checking Fuel line" in every 100
hours maintenance.)
REPLACING POWER STEERING
HOSE
Replace the hoses and clamps.
(See "Checking power steering line" in
every 200 hours maintenance.)
Summary of Contents for CK22
