KINROAD 150 SERVICE MANUAL VERSION 1, DEC., 2005
41
ELECTRICAL STARTING MECHANISM
STARTER MOTOR REMOVAL
Remove the starter motor lead wire clamp.
Remove the starter motor holding bolt, and remove the starter
motor.
Roll up the rubber water-resistance cover, and remove the
starter motor joint.
Remove the motor case bolt, the carbon brush seat and the
motor case etc.
ARMATURE INSPECTION
Inspect the armature surface for uneven wear or damage or
burn.
When where are metal fines attached to the gap of the
armature surface, use a cleaning cloth to remove them.
Measure the conducting condition of the armature coil
according to the picture. It should be conductive.
Measure the conducting condition between the armature coil
and the armature according to the right picture. It should be
non-conductive. If not, it should be replaced.
z
Before removal, first shut off the main switch, and disconnect
the battery connecting wire. Then press the starting button. At
this time the starter motor should not run. This must be done for
insuring safety.
z
Please do not use sandpaper to grind, and do not
wash it in any solvent which can dissolve or damage
its insulation.
