3. Mounting
7
Panel mount (required panel mount kit)
·
Cut a hole in the panel with the described
dimensions (page 20)
· Remove the Front Lid unscrewing two screws
· Disconnect the modules
· Separate the front cover by unscrewing two
screws
· Remove the required knock outs from Back Box
for the cables to pass through (always separate
front cover before removing the knock outs)
· Attach the Panelmount Seal, ensure that it is
on the right position
· Insert the Back Box into the panel cut out
· Attach the four panel mount fixing clips
(supplied), to the four studs at either side of
the unit (page 20)
·
Tighten the four Panelmount Fixing Screws
·
Insert the cable glands
·
Pass the cables through the glands
·
Mount the Front Cover on the Back Box
·
Insert the modules
·
Connect the power supply cable and sensors
·
Tighten the cable glands
·
Mount the front lid
·
Operating temperature: 0˚C - 40˚C
·
Relay’s max switching current: 5 A
Wall mount
·
Drill four holes in the wall, according to the
template and insert the wall plugs
·
Remove the Front Lid by unscrewing two screws
·
Disconnect the modules
·
Separate the front cover by unscrewing two
screws
·
Remove the required knock outs from Back Box
for the cables to pass through (always separate
front cover before removing the knock outs)
·
Insert the cable glands
·
Screw in the Back Box to the wall
·
Pass the cables through the glands
·
Mount the Front Cover on the Back Box
·
Insert the modules
·
Connect the power supply cable and sensors
·
Tighten the cable glands
·
Mount the front lid
TMS300 CS Multi-Tank – User Manual
Note: This device should be properly earthed. Flexible wires simplify connection to the terminals.
All connections should be secure and adequately tightened. It is good practice to keep mains cables
away from sensor cables and other low voltage signal cables.
·
Supply voltage: 110-240 V AC or 12-24 V DC
·
Max input power: 24 V A
