*The large sponge may be used alone (without
small sponge & water).
3. Dampen the large cleaning sponge and place it
on the iron holder base.
Connections
!
CAUTION
: Be sure to turn off the power switch before connecting or disconnecting the
soldering iron. Failure to do so may result in damage to the soldering station.
1.
Connect the cord assembly to the
receptacle.
2.
Place the soldering iron in the iron holder.
3.
Plug the power cord into a power supply.
Be sure to ground the unit.
4.
Turn the power switch on.
The temperature is preset at 300
℃
or 350
℃
at the factory.
The heater lamp flickers when the
temperature has stabilized.
5.
Press the * button to display the preset
temperature. It will be displayed for two
seconds.
Setting the temperature
Set Temperature Normally
!
CAUTION
: Make sure the temperature of the station can be adjusted (password is OK or
the password is initial).While setting the temperature normally, the heating
element is off.
If the “*” button is pressed for less than one second, the present temperature setting will be
shown for two seconds and then the display will return to showing the tip temperature.
Example:400
℃
to 350
℃
1.
1.
Press the
*
button and hold it down for at least
one second. The left-most digit (the 100’s
digit) in the display will flash. This indicates
that the station is in temperature setting mode
and that the 100’s digit can be adjusted.
2.
Select the desired value for 100’s digit. Using
the
▲
or
▼
button will change displayed
