5. Instructions of remote control pairing
7. Error indicator light
8. Networking and firmware upgrading
6. Wi-Fi indicator light
04 Learn to Use the Treadmill
11
12
If the remote control has no response or you’ ve
changed a new one, the remote control and walk-
ing device need to re-establish communication.
Pairing method:restart the machine,and keep
pressing the mode button for 5s.
Le aving the factor y,the trea dmill is at wait-
ing-for-connection status.User can bind it directly
with APP.
If it is needed to configure the network again,you
can long press the standby button on the display
board,until the treadmill comes out the sound of
“beep” and the Wi-Fi indicator light starts to flash.
Firmware upgrading:You may receive the updating
prompt from your app.Please view the updating
introduction,and operate on your mobile phone
according to it to complete the firmware upgrada-
tion.During firmware upgrading,the display panel
shows UPG.
Waiting for fast connection Slow flashing
In network connection Fast flashing
Successfully connecting Normally on
to the router
Successfully connecting No indicator
to the cloud
E01: Drive communication fault
E02: Motor abnormalities.
E05: Overcurrent protection
E06: Motor protection.
E08: Sensor fault.
E09:Wi-Fi connection failure.
Automatic mode
4. Instructions of automatic mode control (advance mode)
This is a challenging and higher-class mode, you can operate
the treadmill completely out of remote control. It’ s better to use
Automatic Mode after being familiar with the machine.
Function button and mode button can work in this mode.
Note:Automatic Mode is available only when the treadmill is in the
walking mode.
Entering this area, the
Treadmill will start or
accelerate under the
automatic mode.
Entering this area, the
Treadmill will slow down
automatically under the
automatic mode.
