Kingsman ZVFB2410MVN, Owner'S Operation And Installation Manual

Page: 17 / 26

17
TRIM ASSEMBLY AND INSTALLATION
DESIGNER TRIM INSTALLATION
1. Slide the two top support tabs into slot of top trim piece as shown. (Fig.1)
2. Place two part L brackets and backing plates into 45 degree cut ends of trim and tighten screws. If this is a four piece trim repeat for
bottom assembly.
3. Place magnet onto inside corners of L brackets and onto face of bottom retainer bracket.
4. Center top support tabs approximately 5” from either side of trim. Place trim onto fireplace by hanging trim from support tabs and Magnets.
(Fig.2)
* Careful: To avoid scratching paint on face of trim DO NOT place trim on hard surfaces.
1. On the back side of trim top there are two support tabs, using a small screwdriver bend tabs up 90 degrees. Tabs can also be bent by
hand or pliers once partially bent up.
2. Place four supplied magnets onto center of each magnet platform. (Fig.1)
3. Place trim onto fireplace by hanging trim from support tabs and magnets (Fig.2)