Kingsman ZCVRB47, Installation Instructions Manual

Page: 77 / 85

ZCVRB47 & ZCVRB60 - Air Intake Adjustment Plate -
For Vertical Venting and Power Venting
Must be Adjusted Before any Medium Base is added.
The Air Intake Adjustment Plate must be set at
the correct position for the fireplace to function
properly.
Location- The Air Intake Adjustment Plate is
located at the back of the Firebox underneath
the False Bottom.
Access-
To access the Air Intake Adjustment
Plate, Remove the DT Screws from the False
Bottom and remove it. Refer to
Burner System
Removal / Installation
in the manual.
The Air Intake Adjustment Plate is set in the Top Position position at the factory.
Picture #1 Picture #2 Picture #3
Top Position (Factory Setting) Middle Position Bottom Position (1/8” Gap)*
For Vertical Runs Less than 10 Feet – See Picture #1 - Top Position (Factory Setting)
For Vertical Vent Runs 10 Feet Long – See Picture #2 - Middle Position
For Vertical Vent Runs 15 Feet Long or more – See Picture #3 - Bottom Position (1/8” Gap)*
For Power Vent Runs Less than 25 Feet – See Picture #2 - Middle Position
Any further adjustments are to be made with Power Vent Controls
For Power Vent Runs More than 25 Feet – See Picture #1 – Top Position (Factory Setting)
Any further adjustments are to be made with Power Vent Controls
Air Intake
Adjustment
Plate
Air Intake
Adjustment
Plate
Air Intake
Adjustment
Plate
Air Intake
Adjustment
Plate
1/8”GAP
*NOTE: It is important to ensure
there is a 1/8” Gap along the
Bottom of the Air Intake
Adjustment Plate.
Otherwise, the fireplace will not
operate properly.
77