17
h) Valve and Burner Replacement
For valve replacement it is recommended that the
burner assembly be removed, this is done by removing
two 1/4” hex screws on the left and right side of the
firebox and lifting the complete burner assembly from
(the unit and replacing defective component and re-
installing. Check for gas leaks after replacing burner
assembly.
WARNING
The appliance area must be kept clear and free from
combustible materials, gasoline and other flammable
vapours and liquids.
14. BAY WINDOW INSTALLATION
Follow all installation instructions and testing of the unit
before installing Bay Window. Turn unit off and let the
unit cool down before installing.
Attach extension knobs (Hi/Lo), (On/Off) to valve. Then
slide variable speed and piezo bracket forward by
loosening screw and secure.
Attach Bay Window Assembly by inserting clips onto
bottom channel and screw into place at top door
channel.
NOTE: The Bay Window assembly replaces the upper
glass retainer provided with the original unit. Insert flat
glass retainer and tighten, making sure glass does not
fall forward.
(See Bay Window figure 6
on page 18)
Warning and Cautions.
• Do not clean when the glass is hot.
• Do not use abrasive cleaners.
• Using a substitute glass will void all product
warranties.
• Do not strike or abuse glass. Care must be
taken to avoid breakage of the glass.
• Do not operate this fireplace without the glass
front or with a broken glass.
Glass Replacement
REPLACEMENT GLASS
Only Robax ceramic or coated NeoCeram glass may
be used for replacement. The glass must be a minimum
of 5mm thick.
Removal of the Glass Door
1. Remove the door by unscrewing the two (2) top
screws of the top channel and loosening the bottom
channel.
2. Once the top of the door is unlatched, pull it out
wards and up to unlatch the bottom.
3. To re-install, place the bottom door ledge into the
lower channel assembly first. Now, swing the door
closed to seal it against the firebox cavity. Re-attach
the upper channel assembly to secure the door to the
appliance. Tighten 4 screws.
4. To replace the class, clean all gasket materials from
the door frame. Using a high heat silicone (resistant to
500º [260ºC]) apply a bead of approximately 1/32’ to
all four sides of the frame and insert the glass with a
new gasket. The door frame should be on a flat surface
with a small amount of weight pressing the glass into
the silicon. Let everythng dry for approximately 15 to 20
minutes. The door can be re-installed by following step
3.
(f) Brass Trim and Surround
All Brass and Painted surfaces should only be wiped
off with a soft non abrasive damp cloth ( a mild dish
soap can be used if necessary ).
DO NOT
use brass or other metal polishes,
glass cleaners or any other abrasive cleaners
as this will mark and damage brass or painted
surfaces.
(g) Venting
Venting should be inspected yearly by a qualified
service technician and replaced if necessary . Draft
action should be tested for as outlined in Section
9
to
conform that conditions in the house have not changed
or that the vent has not become blocked or damaged.