Installation Instructions
Model Number IDV33-IDV36 Gas Fired Direct Vent Room
Heater inserts
Model IDV 33
Listed Certified for USA. and Canada
Certified to: ANSI Z21.88a-2000, CSA 2.33A-2000, CGA 2.17-M91, CSA P.4.1-02
Model IDV 36
Listed Certified for USA. and Canada
Certified to: ANSI Z21.88b/CSA 2.33b-2003, CSA P.4.1-02
Read this complete manual before beginning installation.
These instructions must be kept with the unit for future reference.
FOR YOUR SAFETY
Warning: Improper installation, adjustment, alteration, service
or maintenance can cause property damage, personal injury or
loss of life. Refer to this manual. Installation and service must
be performed by a qualified installer, service agency or the gas
supplier.
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
What To Do If You Smell Gas
Do not try to light any appliance.
Extinguish any open flame.
Do not touch any electrical switch.
Do not use any phone in your building.
Immediately call your gas supplier from a neighbour’s phone.
If you can not reach your gas supplier, call the fire department.
This appliance may be installed in an aftermarket permanently located, manufactured home (USA
only) or mobile home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certified kit is used.
A Division of R-Co. Inc.
2340 Logan Avenue
Winnipeg, Manitoba, Canada R2R 2V3
Ph: (204) 632-1962
Printed in Canada
July 09, 2007
Part # 36IDV-MAN
WARNING: If the information in these instructions are not followed
exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
WARNING: The IDV33/IDV36
Fireplace Insert was designed for
installation in a solid fuel fireplace
that has been installed in accordance
with national, provincial/state and
local building codes and is constructed
of noncombustible materials. Do not
remove any refractory materials
from any masonry solid fuel fireplace.
The IDV33/IDV36 Fireplace Insert
was designed for installation in a
zero clearance type listed solid fuel
burning factory built fireplace. It
may be necessary to remove the
damper plate and refractory liners.
Removal of the smoke baffle is necessary
in most cases.
