21
NOTE: FOR EASE OF INSTALLATION, THE FAN KIT SHOULD BE INSTALLED BEFORE THE STOVE IS PUT IN ITS
FINAL POSITION.
AUTOMATIC ON/OFF THERMOSTAT CONTROLLED FAN KIT (Part #F35FK)
1. Open the front access door where the piezo-igniter is located. Remove the two screws that hold the control panel in place, pull the
control panel out towards you and install the variable speed control in the hole provided opposite the piezo-igniter.
2. Locate the two fan mounting screws in the rear of the unit as shown in the above diagram and place the key holes on the rear of the
fan over the mounting screws and drop into position.
3. Connect the power, sensor and variable speed control as shown in the wiring diagram. NOTE: Sensor is pre-installed on the bottom
burner assembly.
4. Turn the switch on (clockwise). NOTE: The stove must now be installed and gas line attached before proceeding.
5. Turn the stove on. Once the sensor unit reaches operating temperature (in approximately 10 to 15 minutes) the fan will turn on. The
fan can be switched off, if desired by turning the switch fully counter-clockwise.
6. Once the fan has started to turn it may be desirable to adjust the minimum fan speed. Tilt the control panel forward to access the rear
of the variable speed switch. Turn the variable switch to its minimum setting (fully clockwise). Use the set screw on the side of the
variable speed control to increase or decrease the minimum fan speed. (It may be desirable to lower minimum fan speed to decrease
the sound level created by the fan.) Reinstall the control panel.
WARNING
Label all wires prior to disconnection
when servicing controls. Wiring
errors can cause improper and
dangerous operation. Verify proper
operation and servicing.
WARNING
Electrical Grounding Instructions - This
appliance is equipped with a three - pronged
(grounding) plug for your protection against
shock hazard and should be plugged directly
into a properly grounded three-prong
receptacle.
WARNING
A qualified electrician must
connect electrical wiring to
junction outlet for built-in
installation.
Follow all
codes.
OPTIONAL FAN KIT INSTALLATION
Summary of Contents for FVF350
Page 2: ...2...
