20
FIGURE 13 – Installing Brick Panels
INSTALLATION OF BRICK PANEL KIT
1. Open side panels and remove front door and log set. (Skip this
step if components are not installed at this time.)
2. Hold the rear brick panel with both hands on the left-right panel,
tilt the top of panel towards you slightly and pull your
right hand towards you slightly and place panel
directly onto the rear of the firebox.
NOTE: TAKE CARE NOT TO
DAMAGE PILOT ASSEMBLY WHEN
PLACING REAR PANEL.
3. Loosen both brick clips using 1/4”
nut driver. Swing brick clip out of
the way and position side brick
panel up to rear brick panel and
against side of firebox and tighten
brick clip down onto panel.
Repeat this step with the
other side panel.
4. Install log set and front
door.
Summary of Contents for FVF350
Page 2: ...2...
