15
INSTALLING – Burner Systems
CLEANING AND SERVICING OF
BURNER / ODS PILOT
It is recommended to annually inspect and clean the unit to
prevent malfunction and / or sooting. This operation should
be performed by your dealer or a qualified technician.
1.
Remove door. (Refer to
Installation of Door
.)
2.
Remove log set, handling carefully by holding gently at
each end. (Refer to
Log Placement
.) Gloves are
recommended to prevent skin irritation from ceramic.
Annual Cleaning / Inspection
•
Do not use cleaning fluids to clean logs or any part of the
heater.
•
Use a soft bristle brush or a vacuum with brush attachment.
•
Vacuum loose particles and dust from burner ports, valve
and blower compartments.
•
Vacuum any accumulation of lint from primary mixing
tube.
•
Inspect ODS pilot for operation, accumulation of lint at the
air inlet holes.
•
Verify flame pattern and log placement for proper
operation.
•
Verify that all ports ignite and cross over smoothly from rear
to front burner.
FIGURE 11 – Manual and Millivolt Pilot Flames
FIGURE 12 – Millivolt Models
WARNING
Turn off heater and allow to cool before cleaning. Only
a qualified service technician should service and repair
appliance.
Summary of Contents for FVF300
Page 2: ...2...
