11
CAUTIONS AND WARNINGS
DO NOT CLEAN WHEN THE GLASS IS HOT.
THE USE OF SUBSTITUTE GLASS WILL VOID ALL PRODUCT WARRANTIES.
CARE MUST BE TAKEN TO AVOID BREAKAGE OF THE GLASS.
DO NOT OPERATE THIS STOVE WITHOUT THE GLASS DOORS OR WITH A BROKEN GLASS DOOR.
DO NOT STRIKE OR ABUSE GLASS.
GLASS REPLACEMENT
Only Robax ceramic or coated Neoceram glass may be used for replacement. It must be a minimum of 5mm thick.
WARNING:
Do not operate appliance with the glass front removed, cracked or broken. Replacement of the glass
should be done by a licensed or qualified service person.
REMOVAL OF GLASS DOOR
1. Remove two screws at top of door.
2. Pull top of door frame forward and
lift from bottom retainer.
3. Reverse steps 1 & 2 to re-install
door
REPLACING OF
CERAMIC GLASS
Follow Removal of Glass Door then clean
all materials from door frame. Using a high
temperature sealant (temperature-resistant
to 500°F (260°C)) apply a bead of
approximately 1/8" to all four sides of
frame and insert glass with new gasket.
Frame should be placed on a flat surface
with a small amount of weight pressing
glass into sealant. Let dry approximately
15 to 20 minutes. The door can be
reinstalled by reversing Steps 1, 2.
INSTALLATION OF
BRICK PANEL KIT
1. Remove glass door as shown in door
removal diagram.
2. Place back up to rear of firebox, leaving
bottom of panel slightly forward for
support.
3. Loosen both brick clips using 1/4” nut
driver. Swing brick clip out of the way
and position side brick against rear brick
panel and side of firebox. Now swing
clip onto panel and tighten screw.
4. Install log set and glass door.