Installation Instructions
Listed Certified for USA. and Canada
Certified to: ANSI Z21.88-2002/CSA-2.33-2002, CAN/CGA 2.17-1991, CSA P.4.1-02
Listed Direct Vent Gas Fired Free Standing Room Heater
Model Number FDV200 - FDV200P
Stock #’s: FDV200N, FDV200LP, FDV200PN, FDV200PLP
“Free Standing”
Direct Vent Gas Stove
Printed in Canada September 17, 2007 Part # 200-MAN
This appliance may be installed in an aftermarket permanently located, manufactured (mobile) home, where
not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certified kit is used.
A Division of R-Co. Inc.
2340 Logan Ave., Winnipeg, Manitoba, Canada R2R 2V3
Ph: (204) 632-1962
Read this complete manual before beginning installation.
These instructions must be kept with the unit for future reference.
FOR YOUR SAFETY
Warning:
Improper installation, alteration, service or maintenance can cause
property damage, personal injury or loss of life. Refer to this manual.
Installation and service must be performed by a qualified installer, service
agency or the gas supplier.
Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
What To Do If You Smell Gas
Do not try to light any appliance.
Extinguish any open flame.
Do not touch any electrical switch.
Do not use any phone in your building.
Immediately call your gas supplier from a neighbour’s phone.
If you can not reach your gas supplier, call the fire department.
