OPERATING INSTRUCTIONS
Upon completing the gas line connection, a small amount
of air will be in the lines. When first lighting the burner, it
will take a few minutes for the lines to purge themselves
of this air. Once the purging is complete, the burner will
light and operate as indicated in the instruction manual.
Subsequent lighting of the appliance will not require such
purging.
WARNING:
Read and follow the Safety and Lighting
Instructions page in this manual and on labels on the
appliance.
IF YOU DO NOT FOLLOW THESE
INSTRUCTIONS PRECISELY, A FIRE OR
EXPLOSION MAY RESULT AND YOU MAY BE
SERIOUSLY INJURED!
MAINTENANCE INSTRUCTIONS
1. T
he appliance should be inspected before initial use
and inspected and cleaned at least annually by a
qualified field service person.
2. Tampering is
DANGEROUS
and voids all warranties.
If the burner or any other component is found to be
faulty, it must be replaced prior to operation of the
appliance with an approved component. Replacement
burner must be as specified in the manual.
3. To obtain proper operation, it is imperative that the
burner flame characteristics are steady, not lifting or
floating. Check the burner flame patterns with
Log Placement Instructions Section.
4. Periodically remove the logs and examine the burner.
If dirty, clean with a soft brush. Also examine the
area around the burner air shutter. Any dirt or lint in this
area should be removed. This will ensure long life and
trouble free operation. Re-install the logs as shown in
the log placement instructions. When the appliance is
put back in service, check the burner flame patterns
with Log Placement Instructions Section.
5. Periodically check the hose connecting the LP-gas
cylinder to ensure it is not damaged in any way.
HIGH ELEVATION INSTALLATION
U.L. Listed gas fireplaces are tested and approved for
elevations from 0 to 4,500 feet in Canada and U.S.A.
When installing this fireplace at an elevation above 4,500
feet (in Canada), check with local authorities.
Consult your local gas utility for assistance in
determining the proper orifice for your location.
CLEANING
It is recommended to annually inspect and clean the unit to
prevent malfunction and / or sooting. This operation should
be performed by your dealer or a qualified technician.
Carefully remove media (log set, Rocks, Glass, etc.). Gloves
are recommended.
Warning:
Turn off Unit and allow to cool before cleaning.
Only a qualified service technician should service and repair
appliance.
• Do not use cleaning fluids to clean logs.
• Use a soft bristle brush or a vacuum with brush
attachment.
• Vacuum loose particles and dust from burner and valve
• Inspect Burner Plate, Pilot, Valve, and Mixing Sleeve for
spider webs or other blockages.
• Replace media. Refer to the appropriate page in this
manual for proper placement of contents, such as logs.
22
