Kinghome KW09HQ3D6DI, Instruction Manual

Page: 16 / 44

8
Introduction for buttons on remote controller
swing angle will remain original.
When selecting " " with remote controller or no display, temperature indicator on
indoor unit displays set temperature; When selecting " " with remote controller,
temperature indicator on indoor unit displays indoor ambient temperature; When
selecting " " with remote controller, temperature indicator on indoor unit displays
outdoor ambient temperature. 3s later it will return to the setting temperature or it
depends on the other received signal within 3s.
indicates guide louver swings back and forth in the five places, as shown in the figure.
t n e s e r p s ti n i a m e r lli w t i , n w o d d n a p u g n i g n i w s s i ti n e h w d e p p o t s s i r e v u o l e d i u g f I
position.
CLOCK button
One press this key to enter into TIMER OFF setup, in which case the TIMER OFF
icon will blink. The method of setting is the same as for TIMER ON.
10
TEMP button
Press this button, the clock can be set up, signal blink and display. Within 5 seconds,
the value can be adjusted by pr or - button, if continuously press this button for 2
seconds above, in every 0.5 seconds, the value on ten place of inute will be increased 1.
the current time value is Clock value, otherwise is Timer value.
During blinking, repress the Clock button or Confirm button, signal will be constantly
displayed and it denotes the setting succeeded. After powered on, 12:00 is defaulted to
display and signal will be displayed. If there is signal be displayed that denotes
9
TIMER ON/TIMER OFF button
Timer On setting: Signal “ON” will blink and display, signal will conceal, the num-
erical section will become the timer on setting status. During 5 seconds blink, by
pr or - button to adjust the time value of numerical section, every press of
that button, the value will be increased or decreased 1 minute. Hold pr or -
button, 2 seconds later, it quickly change, the way of change is: During the initial
2.5 seconds, ten numbers change in the one place of minute, then the one place
is constant, ten numbers change in the tens place of minute at 2.5 seconds speed
and carry. During 5s blink, press the Timer button, the timer setting succeeds. The
Timer On has been set up, repress the timer button, the Timer On will be canceled.
Before setting the Timer, please adjust the Clock to the current actual time.
no display
Press this button, you can see indoor set temperature, indoor ambient temperature
or outdoor ambient temperature on indoor unit’s display. The setting on remote co-
ntroller is selected circularly as below:
11