Kingfisher KI 9600 Series, Operation & Maintenance Manual

Page: 45 / 52

KI 9000 UM-14
43
QUICK REFERENCE GUIDE – KI 9600 Series Optical Power Meter
•
To remove interchangeable connector adaptor, press
the button on the front of the instrument and pull off
adaptor.
•
To defeat auto power-off, press and hold [POWER] for
3 seconds during turn on. ‘Perm’ is displayed on the top
right of the LCD.
•
Low battery is indicated with a battery symbol.
• During instrument turn on:
-
to view all display segments, press and hold [ λ

]
-
to turn buzzer off, press and hold [

λ ]
-
to display firmware version, press and hold
[HOLD]
-
to start Slow mode, press and hold [dB/dBm/mW
Set Ref]
•
To scroll wavelength, press [
λ

] or [

λ
].
•
To toggle logarithmic/relative/linear display modes,
press [dB/dBm/mW].
•
To stop / start display update, press [HOLD].
•
To set reference, press and hold [Set Ref] for more
than 3 sec. When in reference mode, the reference
value is shown on the left hand side of the display.
•
To display max min recorded power, press and hold
[Max Min]. To re-set this function, press [POWER].
•
When multi-fibre ID tone is detected by a power
meter, a buzzer will sound and the corresponding
fiber ID number will be displayed. This function is
disabled in SlowMode.
•
When a standard tone is detected (eg 270 Hz, 1 KHz,
2 KHz), a buzzer will sound and the corresponding
modulation frequency will be displaye
d
.
•
If the meter detects a test tone higher than 200 Hz,
the display will show the actual measured modulation
frequency in kHz. This function is disabled in
SlowMode.
SlowMode:
•
In SlowMode, the display will show average optical
power of the modulated signal. All tone detection is
disabled