72
• The Light will be white or red.
• The display will show the motor speed from off as “A.O” up to boost as “A.P”.
USING MANUAL MODE AND AUTOMATIC MODE
Automatic Mode
After calibration is completed, the hood will be configured in Automatic Mode and when the hood is turned
on, the sensor will take an initial reading of the air quality in your kitchen.
This will take around thirty seconds and the Air Sense Control will flash white. Once completed the Air
Sense control will change colour according to the air quality and set the fan speed automatically based upon
the table above.
NOTE:
1. If the display shows “A.O”, the Air Sense icon is green, and the air quality does not alter, the hood will
automatically turn off after ten minutes.
2. If the display shows “A.1”, the Air Sense icon is green, and the air quality does not alter, the hood will
automatically drop to “A.O” after five minutes.
Manual Mode
If you wish to control the hood manually you can switch to manual control by pressing the Fan Speed Up
control .The display will change from the current automatic speed and increase the fan speed by one, for
example from “A.1” to “S.2”.
The display will also flash indicating that this is a temporary override and this will continue for five minutes
before returning to the previous automatic level setting.
Once in Manual Mode, you can control the fan speed by using the Fan Speed Down control
and Fan
Speed Up control and by pressing the Air Sense Status control
once, this will confirm the new manual
speed and the display will stop flashing.
Alternatively, press the Air Sense Status control
again to return to Automatic Mode straight away.
Troubleshooting
Problem
Possible cause
Solution
Excessive vibration.
The appliance is not installed properly
on the brackets.
Take down the appliance and check it
is properly fixed.
The fan blade is damaged.
Switch off the appliance. Repair to
be carried out by qualified service
personnel only.
The fan motor is not fixed tightly.
The light is on, but the
fan does not work.
The fan blade is jammed.
The motor is damaged.
Both the light and
motor do not work.
Light bulb blown.
Ring the customer helpline at the end
of the Care & maintenance section to
arrange an engineer visit.
Power connection loose.
Check power supply.
5059340445953_MNL_IN_V04.indb 72
5059340445953_MNL_IN_V04.indb 72
09-06-2022 14:31:37
09-06-2022 14:31:37
