Press
MENU
to enter setting interface, and /
to choose window detector
function . When is flashing, press
OK
to enter setting interface. Then press
/
to choose “
ON
” or “
OFF
”. If “
ON
” is selected, the window detection function is
activated and icon will show on the screen. Press
OK
to confirm or wait 30 s
for the device to save automatically and return to the operating interface.
When temperature decrease detected, the appliance will automatically enter
anti-freeze mode with icon flashing. If temperature rises up, the appliance will
go back to previous mode with icon on. You can choose “
OFF
” to inactivate the
window detection function.
Remarks: the window detector function is not available under anti-freeze mode.
16
EN
Quick start
3. Window detection mode
Hour
(01 is for hour 1 to hour 2, and so on,
24 is for hour 24 to hour 1)
2. After setting of 24 hours, press /
or
OK
, it will automatically save and go back
to previous setting interface.
For example, if you enter the P3 setting from below interface (day 1, P3), it will go
back to below interface (day 1, P3) after you finish P3 24-hour setting. The updated
P3 program has already replaced the manufacturer default P3 setting.
Notes:
1. In case of power failure, the unit keep in memory only the parameters,
temperature and operating mode. When power is restored, the clock should be
adjusted again to operate the program modes properly.
2. After you finish program mode setting, it will be saved but will not
automatically start working at program mode. You need to press left/right arrow
button to choose program mode to make the heater work at this mode.