Kingcraft
6
Always check that the voltage of the battery pack matches the voltage specified on
the power label of the charger. Also check that your voltage matches the input
voltage of the charger.
Replacing cables or plugs
If the power cable of this device is damaged then, to minimize danger, the manufacturer, their
customer service department or another suitably qualified person must replace it.
•
Remove the battery pack. When the electric tool is not being used, before maintenance
and when changing tools such as (e.g.) drills, bits.
Additional safety instructions
1.
Only use the accumulator block with the battery charger provided – using other chargers
could be dangerous.
2.
Keep the accumulator block, tool and battery charger away from damp and wet conditions.
3.
Before using the battery charger, check all wires are properly connected.
4.
If any wires on the charger are damaged, do not use it until these have been replaced.
5.
When the charger is not in use it should not be plugged in. When unplugging, do not pull the
plug out by the cable.
6.
If the charger breaks down or suffers from other technical problems, take it to a recognized
dealership to be checked before using it again. Any damaged parts must be replaced.
7.
Take care when handling the accumulator block, do not drop it or knock it against other
things.
8.
Never attempt to repair the battery charger or accumulator block yourself; this can be
extremely dangerous. Repairs should always be carried out by a
recognised dealership.
9.
Always unplug the charger before cleaning or carrying out any other maintenance on it.
10. Do not attempt to charge the accumulator block in temperatures of below 41 degrees
Fahrenheit or above 104 degrees Fahrenheit.
11. Never throw the accumulator block into water or a fire – it may explode.
12. Turn the drill immediately off after the screw is fastened. Overloading and damaging the
battery or motor can be prevented this way. Use the torque to loosen the fastened screw.
US
D
NL
F
E
P
I
S
SF
N
DK
H
CZ
SL
PL
RU
GR
9
Kingcraft
Intended use
This screwdriver is intended for tightening and loosening screws (fig. 2 - 6). The screwdriver is
not suitable for screwdriving heavy constructions, for example repairing a big fence.
Package contents
1
Cordless screwdriver
1
Charger
1
Magnetic bit holder
18 Accessories
1
Instruction manual
1
Warranty card
Check the machine, loose parts and accessories for transport damage.
Technical specifications
Charger input
120V / 60 Hz / 8 W
Charger output
3,6 V / 600 mA
Battery capacity
1,1 Ah
Charging time
4 - 5 hours
Max. torque
3 Nm
No-load speed
230 r/min
Weight
340 gr.
6. TECHNICAL SPECIFICATIONS
fic
ations
US
D
NL
F
E
P
I
S
SF
N
DK
H
CZ
SL
PL
RU
GR
