King Technology Perform-Max 920, Manual

Page: 9 / 18

9
12" to 15"
12" to 15"
POOLSA
NITIZER
PVC
CEMENT
TOOLS NEEDED
Pipe Wrench
Hacksaw
Tape Measure
MATERIALS NEEDED
Pipe Thread
Sealant
Primer and
PVC Cement
Two 2” Threaded
x 2” or 1 1/2” Slip
Male Adapters
(not Included)
RECOMMENDED
Corrosion Resistant
Check Valve
#10 x 1 1/4” Phillips
Pan Head Screws with
Washers
1.
2.
PVC
CEMENT
In Ground, In-line Installation - Model 940
OR
Do NOT install in copper pipe
as chemical corrosion occurs.
Do NOT install an in-line
Perform-Max off-line.
Bi-flow valve design allows
water flow in either direction.
Following pipe thread sealant
directions, brush sealant
onto Perform-Max threads
in both ports and both male
adapters.
DO NOT USE
PIPE THREAD TAPE
Screw a male adapter
into each port of Perform-Max.
Hand tighten. Finish
tightening by turning
1 to 2 revolutions
with wrench.
DO NOT
OVER
TIGHTEN.
Insert PVC pipe into male
adapters with a twisting
action. Hold in place
5 to 10 seconds to bond.
Isolating the Perform-Max by
installing a corrosion resistant
check valve is recommended.
3.
4. 5.
6.
7.
• Install after all equipment and
as far as possible from heater.
• Any additional sanitizing
equipment that is installed with
Perform-Max must be installed after
Perform-Max (never before) on the
return line to the pool.
Measure the distance
between Perform-Max male
adapters and cut out a
section of pipe 3” less than
that dimension.
Following Primer directions,
brush Primer on the inside of
the male adapters and to ends
of pipe. Repeat this process
with PVC cement following
directions on that product.
Leave 12” to
15” above and
around Perform-
Max to allow
room for easy
refilling.
PUMP
FILTER
HEATER
(If
Installed)
*CHECK
VALVE
POOLSA
NITIZER
Use Phillips
pan head
screws
through the
mounting
holes at the
Perform-Max
base to secure the Perform-
Max into a treated wood
base.
Perform-Max 980
Use the 2” x 1 1/2”
threaded bushing provided
for steps 1 through 3.
Repeat steps 1 through 3
using a 1 1/2” threaded
by 1 1/2” slip bushing (you
provide). Then follow the
remaining inline installation
instructions.
2” x 1 1/2”
Threaded
Bushing 1 1/2”
Threaded by
1 1/2” Slip
Bushing