King Kutter Free Floating Finishing Mower, Owner'S Manual

Page: 40 / 44

40
BONDIOLI- (BYPY)
1). There are 3 white tabs around the cover as shown in (A in FIG. 1). Take a
screwdriver and press against the tabs one at a time with downward an-
gular pressure toward the end of shaft marked
(B in FIG. 2). As you are
pressing tab grasp cover at point marked (B in FIG. 2) and apply pres-
sure against cover in the direction of arrow, do this for each tab. (Some-
times the other tabs may relock, if they do you must repeat unlock proce-
dure.) You will feel it click when the tab releases, after all 3 tabs are re-
leased you can slide the cover down the shaft in direction of
(C in FIG. 2) .
2) To put cover back into place slide cover back toward end until all the tabs
relock. (You may have to tap lightly with screwdriver or hammer handle).
NOTE: Cover may be longer on some models but, they will come off
the same as above.
EUROCARDAN SERIES 4
1) First you must locate the black tab (D in FIG. 3) put flat screwdriver in slot
in end of tab and turn until the flat side is pointing towards center of shaft.
Once you do this take the thin flat screwdriver and put into slot labeled
(E
in FIG. 3) pry tab all the way out as shown in (FIG. 3)
2). There are 3 white tabs around the cover as shown in (G in FIG. 4). You
must line up cover slots and tabs (as shown in FIG. 4, F & G) Take a
screwdriver and press against the tabs one at a time with downward an-
gular pressure toward the end of shaft
. As you are pressing tab grasp
cover and apply pressure against cover in the direction of arrow, (H in
FIG-3) do this for each tab. (Sometimes the other tabs may relock, if they
do you must repeat unlock procedure.) You will feel it click when the tab
releases, after all 3 tabs are released you can slide the cover down the
shaft in direction of
(H in FIG. 3) .
3) To put cover back into place slide cover back toward end (be sure tabs
and slots line up) until all the tabs relock. (You may have to tap lightly with
screwdriver or hammer handle). Once they have relocked replace black
tab that was removed with flat side toward shaft center then turn flat side
up to lock in place.
LA MAGDALENA
1) There are 3 black tabs around the cover (K in FIG. 5). Take a screwdriver
and press against the tabs one at a time with downward angular pressure
toward the end of shaft marked
(J in FIG. 5). As you are pressing tab
grasp cover at point marked (J in FIG. 5) and apply pressure against
cover in the direction of arrow, do this for each tab.
2) To replace slide cover back toward end and line up black tabs with the
holes and lock in place.
PTO SHAFTS COVER REMOVAL