ROUTER TABLE
ASSEMBLY AND ADJUSTMENTS
INSTALLATION GUIDELINES
This router table attachment can be mounted on most table saws having a 27” deep
table. If your table saw doesn’t have mounting holes to install the router table,
drilling or drilling and tapping holes will be necessary.
This router table attachment normally gets installed to the right side of the table of
your table saw, but it can also be installed on the left side. For the purpose of these
instructions, we will instruct you on installing the router table to the right side of the
table. Fig.1 shows the router table completely assembled. The following instructions
can also be applied to the installation of the router table on the left side of table.
WARNING!
Unplug table saw power cord from power source before attempting to
assemble this router table attachment.
INSTALLING ROUTER TABLE TO YOUR TABLE SAW
There are
2 options
to mount the router table attachment, decide which of the
following best suits your needs;
Option #1
- Mount the router table attachment directly to the main table of your table
saw (Fig.2). Disassemble and remove the right side extension wing (if mounted to
your table). Use the extension wing mounting hardware (three M8 x 1.25 cap
screws, spring washers and washers) to install router table. Only hand tighten at
this point.
Option #2
- Mount the router table attachment directly to the right side extension
wing. To do this, you will need to drill and tap M8 x 1.25 mounting holes into the
right side extension wing. Use the router table mounting holes as a guide. Use the
supplied mounting hardware (three M8 x 1.25 cap screws, spring washers and
washers) to install router table to extension wing. Once installed, only hand tighten
at this point.
INSTALLING SUPPORT LEG TO ROUTER TABLE
1) Once the router table is secured to the table, install the support leg (A) Fig.2
underneath the front edge of the router table. To install, screw support leg set
screw into table, then screw support leg.
2) Install the adjustable foot (B) Fig.3 to the support leg (A). To install, screw it into
the bottom of the support leg. At this point, do not tighten the hex. nut (C) against
the bottom of the support leg.
ADJUSTING ROUTER TABLE FLUSH WITH TABLE TOP
1) The top of the router table must be installed flush with the top of the table. To do
this, place a straightedge (A) Fig.4 on top of both tables. Adjust the height of the
router table, once perfectly flush with the table top, tighten the router table
mounting hardware.
2) Adjust the support leg adjustable foot (B) Fig.3 in or out to adjust height of
support leg until the front edge of the router table is perfectly level with the table.
Once properly adjusted, tighten the hex. nut (C) Fig.3 against the bottom of the
support leg (A) as shown in Fig.3.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
Option #1
