ASSEMBLY
Clean all rust protected surfaces with ordinary house hold type grease or spot
remover. Do not use: gasoline, paint thinner, mineral spirits, etc. These may
damage painted surfaces. Apply a coat of paste wax to the tables to prevent rust.
Wipe all parts thoroughly with a clean dry cloth.
INSTALLING BELT AND DISC SANDER ONTO CABINET STAND
1. Position the cabinet stand (A) Fig.5 on a firm and level surface.
2. Lift the Belt and Disc sander (B) onto the top of the cabinet stand.
3. If you are assembling model KC-790FX-DC with the built-in dust collector onto
the cabinet stand, make sure to pass the dust collector cord (C) into the small
hole in the top of the cabinet stand as shown.
4. Line up the mounting holes in the base and the cabinet stand. Insert 4 long hex.
bolts and washers into the mounting holes. Open the cabinet door and secure
the base to the cabinet stand using 4 hex. nuts and washers.
5. If you are assembling model KC-790FX-DC with the built-in dust collector,
connect the dust collector cord (A) Fig.6 to the dust collector motor cord (B) as
shown. Also make sure the dust bag (C) Fig.6 is clamped properly with the wire
clamp (D).
WARNING!
The Belt and Disc Sander with Built-in Dust Collector (model KC-790FX-
DC) should not be used for any metal sanding operations. Hot metal and sparks
generated by sanding metal will increase the risk of serious fire and/or damage to
the dust collector system. Metal sanding should be performed using a Metal Sander
connected to a Metal Dust Collector.
INSTALLING CABINET STAND DOOR KNOB
1. Install the cabinet stand door knob (A) Fig.7 and the door bolt (B) to the door as
shown using a 17mm open end wrench.
INSTALLING 4” DUST CHUTE (KC-790FX ONLY) TO CABINET STAND
1. Remove the 4 hex. nuts (A) Fig.8 from the left side of the cabinet stand, keep the
4 screws (B) in place on the inside of the cabinet stand.
2. Install the 4” dust chute (C) onto the 4 screws (B) and secure it to the cabinet
stand with the 4 hex. nuts (A) removed previously.
WARNING!
The 4” diameter dust chute allows for connection to a dust collector, do
not use this Belt and Disc Sander without an appropriate dust collection system.
Failure to follow this warning could lead to equipment malfunction and dangerous
situations.
Figure 5
Figure 6
Figure 7
Figure 8
