ADJUSTMENTS
ADJUSTING SANDING BELT TABLE AND 45º/90º BEVEL STOPS continued...
To adjust the 45º & 90º bevel stops of the sanding belt table:
1. Loosen spring loaded handle (A) Fig.13 and raise the sanding belt table until the
table is stopped by the 90º bevel stop screw (B). Retighten spring loaded handle.
2. Place a square (C) on the sanding belt table and up against the sanding belt.
Make sure the sanding belt table is set perfectly at a 90º angle.
3. If the sanding belt table is not set at a perfect 90º angle, an adjustment can be
made. Loosen spring loaded handle (A), and adjust table to a perfect 90º angle.
4. Loosen 90º bevel stop hex. nut (D) and adjust the set screw (B) in or out until it
rests againt the stop shaft (E). Retighten hex. nut (D).
5. To verify and adjust the 45º bevel stop, lower the table as far as possible until the
table is stopped by the 45º bevel stop screw (F). Use a combination square
instead to verify the table angle. If an adjustment is needed, loosen 45º bevel stop
hex. nut (G) and adjust the set screw (F) in or out until it rests againt the stop
shaft (E). Retighten hex. nut (G).
ADJUSTING SANDING DISC TABLE AND 90º BEVEL STOP
To adjust the angle of the sanding disc table:
1. Loosen lock knobs (A) Fig.14 on both sides of the sanding disc table.
2. Tilt the sanding disc table (B) to the desired angle, use the scale and pointer (C)
as a guide to set the desired angle.
3. Retighten lock knobs once adjustment is done.
To adjust the 90º bevel stop of the sanding disc table:
1. Place a square (A) Fig.15 on the sanding disc table and up against the sanding
disc. Make sure the sanding disc table is set perfectly at a 90º angle.
2. If the sanding disc table is not set at a perfect 90º angle, an adjustment can be
made. Loosen lock knobs (B), and adjust table to a perfect 90º angle.
3. Loosen 90º bevel stop hex. nut (C) and adjust the set screw (D) in or out until it
rests againt the sanding disc table (E). Retighten hex. nut (C).
4. Readjust the angle pointer (F) to indicate 0º.
Note:
The 90º bevel stop can be pivoted out of the way to allow tilting the sanding
disc table downwards.
INSTALLING & ADJUSTING WORK STOP
When operating the sanding belt in the horizontal position, the sanding belt table
can be removed and replaced by a work stop.
1. Loosen and remove the sanding belt table lock handle and washer (A) Fig.16.
Then remove the entire sanding belt table as shown.
2. The threaded stud (B) Fig.16 is installed for sanding belt table installation, the
shorter end of the stud is threaded into the machine. But to install the work stop,
this threaded stud must be removed and flipped around so that the longer end of
the stud is threaded into the machine. Using a wrench on the flat on the stud,
remove stud and reinstall it so that the longer end of the stud is threaded into the
machine. See Fig.17.
Figure 13
Figure 14
Figure 15
Figure 16
