INSTALLING MEASURING TAPE ON GUIDE TUbE
Caution! Only proceed with the following step once the rip fence system has been
adjusted and that the fence is set perfectly parallel with the saw blade. See “Adjusting
Rip Fence” section on the previous page for instructions.
Slide the fence against the saw blade. Place the measuring tape on the tube (A) Fig.1
under the pointer window (A) Fig.4. The pointer window contains 2 small red lines
which represent the thickness of the blade kerf, line up the zero mark of the measuring
tape underneath the red line on the left side. Make sure the measuring tape is
positioned perfectly parallel to the tube and that the measurements are clearly visible.
Remove the fence. Peel away a small portion at a time of the measuring tape backing
and carefully apply it to the tube. We suggest taking your time during this installation,
if a mistake is made and the zero mark does not align perfectly, you can loosen the
pointer window screws (B) Fig.4, reposition the pointer window in the correct position
and retighten the screws.
INSTALLING MAGNETIC SWITCH TO FRONT RAIL
If your King cabinet saw comes with a magnetic safety switch (A) Fig.5 and is
attached to a mounting bracket (B), mount the mounting bracket underneath the left
end of the front rail (C) using 2 cap screws, washers and spring washers.
USING DUO-FENCE DUAL-POSITION ALUMINUM FACING
This rip fence system comes with an adjustable aluminum facing (A) Fig.6 & 7 which
can be positioned in the “high” or “low” position depending on the cutting operation.
Fig.6 shows the aluminum facing positioned in the standard “high” position.
When ripping narrow or thin stock, it is recommended to reposition the aluminum
facing in the “low” position as shown in Fig.7. Installing the aluminum facing in this
position will allow your hand to have a safe place to pass. To change the orientation
of the aluminum facing, follow these instructions:
1) Loosen the 3 lock knobs (B) Fig.6.
2) Slide the aluminum facing forward until the 3 T-bolts (A) Fig.8 exit the T-slot (B) in
the aluminum facing, remove aluminum facing.
3) Turn the aluminum facing sideways to the low position as shown in Fig.7. Use the
low position T-slot (C) Fig.8 to remount it to the fence body.
4) Insert one T-bolt at a time into the low position T-slot as you slide the aluminum
facing against the fence body, once positioned retighten lock knobs (B) Fig.7.
FIGURE 4
FIGURE 5
ASSEMbLY, ADJUSTMENTS
& OPERATION
FIGURE 6
FIGURE 7
FIGURE 8
