OM3008 B.3
™ & © Char-Griller / A&J Mfg.
23
Note: Before starting the grill, check for leaks. Make sure the regulator
valve is securely fastened to the burner and the cylinder.
To prevent fire or explosion hazard when testing for a leak:
1. Always perform the “leak test” as described below
before lighting the grill or
each time the cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a
leak test
.
3. Conduct leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use grill until any and all leaks are corrected. If you are unable to stop a
leak, disconnect the propane supply. Call a gas appliance serviceman or your local
propane gas supplier.
To Perform a Leak Test:
Make a 2-3 oz (0-90ml.) of leak solution by mixing one part liquid dishwashing
soap with three parts water in a spray bottle.
Note: Make sure control knobs are off.
Spray solution on the tank valve to regulator connection, the “Y” joint in the hose,
the connection to the manifold behind the main control panel, and the connection
to the side burner valve.
Inspect the solution at the connection looking for bubbles. If NO bubbles ap-
pear, the connection is secure. If bubbles appear, you have a leak. Check the
regulator connection as follows: Disconnect regulator from the tank and recon-
nect, making sure the connection is secure. Retest with solution. If you contin-
ue to see bubbles, replace the cylinder.
Stand in front of the grill to
operate the controls.
