16
EN
6.2 -
Advanced programming of the
automation’s movement
With this procedure, the control unit memorizes the times and power
required for opening and closing the system.
Moreover, this procedure allows for setting:
- start point of slowdowns or their deletion.
STEP ACTION
RESULT
1
PUT THE DOOR TO HALF
WAY POSITION
2
PRESS THE
SET
BUTTON
FOR 2 SECOND
The yellow “
set
” LED
flashes (if not, consult
Paragraph 14.1)
3
PRESS THE
RADIO
BUTTON FOR 1 SECOND
The yellow “
set
” LED turns
on in the fixed mode
4
THE DOOR PARTIALLY
OPENS
The yellow “
set
” LED stays
on
5
THE DOOR MOVES TO
FULL CLOSING POSITION
The yellow “
set
” LED
flashes
6
PRESS THE
SET
BUTTON
OR A BUTTON OF A
PAIRED
TRANSMITTER
OR CLOSE
START
WIRED CONTACT
The yellow “
set
” LED stays
on
7
THE DOOR PERFORMS
THE OPENING OVEMENT
The yellow “
set
” LED stays
on
8
PRESS THE
SET
BUTTON
OR A BUTTON OF A
PAIRED
TRANSMITTER
OR CLOSE
START
WIRED CONTACT
, TO
SET THE SLOWDOWN
START POINT (*). FOR
NOT HAVE SLOWDOWN,
WAIT UNTIL THE
MOVEMENT HAS BEEN
COMPLETED
The yellow “
set
” LED stays
on
9
THE DOOR COMPLETES
THE OPENING PHASE
The yellow “
set
” LED stays
on
10
PRESS THE
SET
BUTTON
OR A BUTTON OF A
PAIRED
TRANSMITTER
OR CLOSE
START
WIRED CONTACT
The yellow “
set
” LED stays
on
11
THE DOOR PERFORMS
A FULL CLOSING
MOVEMENT
The yellow “
set
” LED stays
on
12
DURING MOVEMENT:
PRESS THE
SET
BUTTON
OR A BUTTON OF A
PAIRED
TRANSMIT-
TER
OR CLOSE
START
WIRED CONTACT
TO
SET THE SLOWDOWN
START POINT (*). FOR
NOT HAVE SLOWDOWN,
WAIT UNTIL THE
MOVEMENT
HAS BEEN COMPLETED
The yellow “
set
” LED stays
on in the fixed mode
13
THE DOOR COMPLETES
THE CLOSING PHASE
The yellow “
set
” LED turns
off
14
END OF THE
PROGRAMMING
PROCEDURE
The LEDs return to the
normal operation
configuration
(*) Minimum slowdown time must be 3 seconds.
If the “FORCE” knob is adjusted, the automation’s move-
ment must be reprogrammed.
The red “Error” LED flashes during the automation’s
movement when a mechanical stress point is detected (this
corresponds to increased motor effort).
Adjust OBSTACLE Adjust OBSTACLE and FORCE knobs
(slightly turn them clockwise) to solve this and check gate
mechanics if necessary.
7.
Testing and
commissioning
Once the programming setup has been completed, verify that:
- the motors turn off after a few seconds once the opening or closing
phases end (also “error” LED turns off);
- the control unit responds to the connected wired commands:
“START” (terminal 7), and “STOP” (terminal 6);
- all programmed radio transmitters are operational;
- the safety devices connected to “S2 Photo” (terminal 4) intervene
while the door closes and prevent the open door from closing;
- the safety devices connected to “S1 Edge” (terminal 9) intervene
while the door opens and closes with a brief movement inversion;
If the “Func” dip-switch is put to ON, check that S2 Photo safety
devices intervene also when the door opens and that they prevent
the closed door from opening.
