King-Dome 9754-LP, Installation And Operating Instructions Manual

Page: 11 / 40

Page 9
11. Run wires from the back of the dome unit to the roof edge, then along edge to location
where wiring will be fed into the vehicle. (If installing an optional auxiliary receiver, run
auxiliary coax to location where it will enter the vehicle.) Secure wiring to roof every 12-
18 inches
(Fig. 10) .
12. Drill 3/4” hole through the roof and into the cabinet where receiver is stored. Feed wiring
down through hole. Seal opening with roof compatible sealant so that it is completely
waterproof (inside and outside of the 3/4” hole). Repeat for auxiliary coax if present.
13. Fasten cable entry cover to roof. Seal mounting holes, perimeter of cover and cable
opening so they are completely waterproof.
Fig. 10
14. Remove blue protective sheet and red “position to rear” sticker from the dome unit.
TYPICAL ROOF INSTALLATION - OVERHEAD VIEW
IMPORTANT!
Sealant must be roof compatible.
IMPORTANT! Sealant must be roof compatible.
Installer is responsible for determining proper roof compatible fasteners for cable entry
cover.
Roof holes for cables must be sealed so they are entirely waterproof. Mounting holes,
perimeter of cable entry cover and cable opening of cable entry cover must be sealed so
they are entirely waterproof.