Page 1
IMPORTANT!
The satellite TV market is expanding and changing. The information in this manual was
accurate at the time of printing. If your Sea-King System does not operate as outlined
in this manual please call King Controls at (800) 982-9920 or visit our website at
www.kingcontrols.com.
TABLE OF CONTENTS
Section
Contents
Page
1.
INTRODUCTION.....................................................................................2
2.
DEFINITION OF TERMS ........................................................................3
3.
INSTALLATION ..................................................................................4-17
4.
OPERATION ....................................................................................18-21
5.
TROUBLESHOOTING.....................................................................22-26
6.
MAINTENANCE ....................................................................................27
7.
LIMITED WARRANTY ..........................................................................28
ELECTRICAL HAZARD WARNING!
The coaxial cable that connects the dome
unit to the tuner carries a 24 volt electrical
current. Exercise extreme caution when
handling this cable. Do not cut, break, or
splice this line. Do not insert or connect
any devices such as splitters or any other
device for any reason. This line is not
compatible with any other equipment.
Damage will occur to any device other than
the dome unit if connected to the antenna
port on the tuner.
DIRECTV is a registered trademark of DIRECTV, Inc.
Dish Network
®
is an official trademark of Echostar Communications Corporation.
Bell ExpressVu
®
is an official trademark of Bell Canada.
DVB
®
is a trademark of the DVB Digital Video Broadcast Project (1991-1996)
Summary of Contents for 9815-RJ
