King Controls 1500-HD, Installation And Operating Instructions Manual, Page: 14 / 40

Page 12
INTERNAL WIRING
1. Choose your desired wiring configuration:
Dish Network/ExpressVU: Fig. 10, Page 13
DIRECTV Fig. 11, Page 14
2. Make all connections as shown in the wiring diagrams.
Apply a light coating of dielectric grease to the female threads of internal coax
connections and to the center stinger of the male coax connections.
ALWAYS CONNECT THE POWER SUPPLY LAST.
3. Perform a search to verify all connections are correct (see page 18).
Note: When the power supply is connected, the controller should turn on for 3 seconds and then turn off. If the
controller stays on, Press the ENTER and “-” buttons simultaneously to turn unit off.
IMPORTANT! The 50’ coax from the “MAIN” port on the dome unit MUST be connected to the Tuner (IDB)
in the vessel.
Coax connections should be snug. DO NOT OVER TIGHTEN!
CONNECT POWER SUPPLY LAST. When connecting the power supply cable to the tuner,
push in the power supply cable end until it is flush against the back of the tuner.
You must apply a light coating of dielectric grease to the female threads of internal coax
connections and to the center stinger of the male coax connections.
ELECTRICAL HAZARD WARNING!
The coaxial cable that connects the dome unit to the tuner carries a
24 volt electrical current. Exercise extreme caution when handling
this cable. Do not cut, break, or splice this line. Do not insert or
connect any devices such as splitters or any other device for any
reason. This line is not compatible with any other equipment.
Damage will occur to any device other than the dome unit if
connected to the antenna port on the tuner.