LEGS ASSEMBLY
NOW, CONNECT THE LEG POLES TO THE ROOF ASSEMBLY WITH THE COVER ALREADY POSITIONED ON
TOP OF THE UNIT.
Step A: First insert the pipes for the middle poles into the 3- and 4-way connectors, and then connect the end
leg pipes in the same way. (See illustration)
Step B: Push the eight foot pads onto the bottom of each leg.
NOTE: the foot pads are NOT for anchoring the canopy!
Step C: Attach the leg skirts to the foot pads.
IMPORTANT! Once the legs and cover are assembled, your canopy
will act like a kite in the wind. It is imperative that the canopy anchors be installed NOW!
Insert Second
Insert First
Your Event Tent has leg skirts for each leg. Make sure the footpads
have been inserted on the leg pipes and eye bolt is turned facing
out. Remove eye bolt and attach the ring at the bottom of the skirt
around the bolt and screw the eye bolt back on the footpad. Pull the
adjustment strap to tighten.
CAUTION: Do not over tighten strap or you could damage leg skirt.
(SEE PICTURE ON RIGHT)
NOTE: The canopy footpads are not intended for anchoring. You
may insert large nails through the hole into the ground to keep
the legs from sliding.
