OPERATION
Sandblasting presents a real hazard of silicosis and other lung contamination injuries!
These injuries are permanent and can get worse over time. If you use sandblasting
equipment without the proper protection, your lungs and eyes may become irreversibly
contaminated. DO NOT use this sandblaster unless you know how to use it and protect
yourself correctly.
If you have never used this type of machine or equipment before, WE STRONGLY
RECOMMEND that you read books, trade magazines, or get formal training before
beginning any projects.
WEAR SAFETY GLASSES AND RESPIRATOR AT ALL TIMES WHEN USING OR
MAINTAINING THIS SANDBLAST CABINET.
1) Before using the Sandblast Cabinet, it is recommended to turn on the LED light for
improved visibility.
2) 4 nozzles are provided with this Sandblast Cabinet, each nozzle has a different inner
diameter. Install the nozzle that best suits your needs.
3) Without creating a large dust cloud, slowly empty up to 35 lbs of abrasive media into
the cabinet.
4) Place your workpiece inside the cabinet.
5) It is recommended to connect a vacuum or dust collector to the rear 2-1/2” dust port of
the cabinet. This will greatly reduce airborn dust inside the cabinet, increasing
visibility.
FIGURE 13
FIGURE 14
OPERATION & MAINTENANCE
Note: If a vacuum or dust collector are not used to reduce airborn dust inside the cabinet, install the dust port cover (A) Fig.13 as shown, and
remove the large plastic cover (B) to uncover large opening (B). This will allow air to flow out of the sandblast cabinet.
6) Close and secure both side doors (A) Fig.14 using the locking latches (B) .
7) Turn on your air compressor and vacuum/dust collector (if used).
8) Position both hands into the glove openings, and begin sandblasting your workpiece. It is recommended to keep the nozzle approximately 2”
away from the workpiece. Start at a lower air compressor setting, adjust as needed. Different pressures and different abrasives will produce
different results, experimentation is needed.
MAINTENANCE
ALWAYS DISCONNECT POWER AND THE AIR SUPPLY TO THE MACHINE BEFORE PERFORMING MAINTENANCE. FAILURE TO DO
THIS MAY RESULT IN SERIOUS PERSONAL INJURY.
Always check the following each time you use the Sandblast Cabinet. Replace any parts that are found to be worn or damaged:
• Excessively worn or cracked nozzles.
• Make sure all fittings are tight and not leaking using soapy water and a spray bottle.
• Check the media collecting hose for thin walls and signs of bubbling.
Keep sandblast media moisture-free at all times. If moisture gets into the sandblast media, it will frequently clog the sandblast gun. Cleaning the
gun and its nozzle will be required if this happens. Reduce moisture in the sandblast media before using again.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.
