FIGURE 7
ADJUSTMENTS
WARNING!
Turn off the saw, remove the main On/Off switch safety key and unplug the
power cord before making any adjustments on the saw.
ADJUSTING POSITION OF THE THE UPPER BLADE GUIDE ASSEMBLY
The upper blade guide assembly (C) Fig.7 should always be set about 1/8” above
or as close as possible to the top of the surface of the workpiece being cut.
1) Loosen the upper blade guide assembly lock knob (A) Fig.7.
2) Turn the upper blade guide assembly adjusting knob (B) to position the blade guide
assembly (C) 1/8” above the surface of the workpiece.
3) Tighten the upper blade guide assembly lock knob clockwise to secure the adjusting
knob.
ADJUSTING THE TABLE
1) Loosen the table lock knob (A) Fig.8.
2) Tilt the table to the desired angle using the bevel angle scale (B) Fig.8 and pointer (C)
as a guide.
3) Retighten the table lock knob by turning it clockwise to secure the table angle.
SETTING TABLE SQUARE TO THE BLADE
1) Loosen the upper blade guide assembly lock knob (A) Fig.7 and position the upper
blade guide assembly all the way up. Retighten the lock knob.
2) Loosen the table lock knob (A) Fig.8.
3) Place a small square on the table against the flat side of the blade or as close as
possible as shown in Fig.9.
4) Set the table to a perfect 90
0
angle to the blade and lock the table using the table lock
knob. Loosen hex. nut (D) Fig.8 under the table and turn the table 0
0
positive stop bolt
(E) until it touches the table. Retighten the hex. nut after the adjustment is done.
5) Check the blade squareness to the table. Readjust if necessary.
6) Adjust the pointer (C) using a #2 Phillips screwdriver, position pointer at the 0
0
,
retighten pointer screw.
FIGURE 8
FIGURE 9
