ASSEMBLY & ADJUSTMENTS
INSTALLING MITER SAW AND MOUNTING
BRACKETS ON STAND
1) Position the miter saw and attached mounting
brackets onto the top of the stand, place the rear of
the mounting brackets onto the rear stand bar first,
once installed on the bars, lower the mounting
bracket lock handles (A) Fig.4 to secure the
assembly in place.
ADJUSTING FIT OF MOUNTING BRACKET
If a mounting bracket (A) Fig.5 is too loose or too tight
on the stand frame, an adjustment to the mounting
bracket can be made.
1) Position the mounting bracket (A) upside down as
shown in Fig.5.
2) Using an open wrench key and a screwdriver,
loosen hex. nut (B) then adjust the pan head screw
(C) in or out until the correct adjustment is done.
3) Tightening the pan head screw will move the plate
(D) inwards for a tighter fit on the stand frame. Loos-
ening the pan head screw will move the plate out-
wards for a less tighter fit on the stand frame.
FIGURE 5
FIGURE 4
