29
7
.
RS232 control
The free
configuration software
or a
media control
also permits controlling the entire
QuickSelect
system
via the RS232 connection in all details.
The
HDBaseT
-Bus can also transmit
RS232-control commands
for controlling further devices such as
projectors and display, bidirectionally (pass through). Connect e. g. the RS232-interface of the media
control simply to a RS232-terminal.
The detailed RS232-protocol and a driver for Neets controls can be found online at:
shop.kindermann.de/evp/webshop/navigation_Path/7447000400.html
Enter RS232 commands and read out answers:
You can use these text fields to send RS232 commands and read the
response of the QuickSelect 3.0 chain. All values are displayed in HEX.
The commands of the respective control commands are automatically
entered under RS232-TxD (Hex) and may be copied, e. g. for the purpose
of driver creation for media controls. The same applies to the respective
device feedbacks.
Note:
ALL commands entered under RS232-TxD are always sent in
sequence. If only a single command is to be sent, please clear the field
first and enter the individual command.
8. Operation by ShowMe button
Every
QuickSelect
has connections for three external buttons with status LED at the rear so that the
user can select every input separately as well, e.g. in a table connection field. Install the
QuickSelect
under the table with the mounting brackets so that the label points up; wire the connection field with
the
QuickSelect
accordingly.
The rear ShowMe-connection acts like the integrated ShowMe-button. If only one source is connected,
the active input is automatically chosen when pushing the ShowMe button. Otherwise, the inputs are
switched through cyclically.
e. g. customised module carrier (no. 7449000318)
LED
NC
NO
C
+
-
GND
KEY
