7
RANGER PRO 12V AIR COMPRESSOR
Pumping up High Volume Inflatables
1.
Ensure that the 12V Air Compressor has been disconnected from the power source before installing/unistalling adaptors.
2.
Follow the instructions for “Connecting/Disconnecting Adaptors
(15,16, 17 or 18) to the Air Supply Hose (10)” located on page 5
to install the appropriate High Volume Adaptor (15 or 16) (Fig 19).
3.
With the desired High Volume Adaptor (15 or 16) installed on your Brass Coupler (6), insert the connected adaptor into
the inflatable item (Fig 20).
4.
Follow the instructions for“Turning ON/OFF the 12V Air Compressor”, turn ON the 12V Air Compressor.
5.
Remove the High Volume Adaptor (15 or 16) once the item is fully inflated. Continue to inflate other items you may
wish to inflate (Fig 21).
6.
Once all items have been inflated, turn the 12V Air Compressor OFF via the ON/OFF Switch (3) & disconnect the Battery
Terminal Clamps (1 and 2) from the vehicles battery.
Pumping up Bike Tyres (Presta Adaptor)
1.
Identify the required pressure for the tyre to be inflated, this is usually displayed by the safety warning located on the tyre.
2.
Remove the desired tyres Presta cap.
3.
Ensure that the 12V Air Compressor has been disconnected from the power source before installing/unistalling adaptors.
4.
Follow the instructions for “Connecting/Disconnecting Adaptors
(15, 16, 17 or 18) to the Coiled Air Hose (10)” located on page 5
to install the Presta Valve Adaptor (18).
5.
With the Presta Valve Adaptor (18) installed into your Brass Coupler (6) (Fig 22), screw it onto the bicycle’s tyre
Presta Valve (Fig 23).
6.
Once connected, follow the instructions for“Turning ON/OFF the 12V Air Compressor”, turn ON the 12V Air Compressor.
7.
When the Pressure Gauge (8) reaches your tyre pressure rating (Fig 24), turn the 12V Air Compressor OFF via the ON/OFF
Switch (3) and remove the Presta Adaptor (18) from the bicycles Presta valve.
8.
Reinstall Presta valve cap removed in step two.
(Fig 19)
(Fig 20)
(Fig 21)
(Fig 22)
(Fig 23)
(Fig 24)
Problem
Cause
Solution
The Compressor will not
start.
Compressor not
connected to power.
a)
Connect the 12V Battery Terminal Clamps (1 & 2) to a
12VDC Battery & earth ground point.
b)
Battery terminals have poor connection, clean and re-fit battery
terminal clamps
Insufficent power supply.
Try another battery, as it may be flat or faulty.
Thermal cut-out activated. Wait 20-30 minutes for the 12V Air Compressor to cool down and press
the Thermal Overload Cut Off Button (14).
The Compressor starts,
but there is no pressure.
Loose or damaged hose
connection.
Inspect the 12V Air Compressor Air Supply Hose (10) and
Adaptors (15,16,17 & 18). Replace if necessary.
The seals are damaged.
Contact Kincrome Customer Service on 1300 657 528 .
Summary of Contents for RANGER PRO K13010
Page 12: ...www kincrome com au...
