POWER PAK PLUS
7
POWER PAK PLUS Pre-Operation Check (Cont.)
The POWER PAK PLUS is fitted with INTELLI-CHECK jumper cables. Familiarize yourself with the features of the INTELLI-
CHECK as per below once connected to your vehicles battery.
INTELLI-CHECK LED / Noise and Button Indicators
Note: Do Not press the “BOOST” Button prior to connecting the jumper cables to your vehicle.
Note: Once the POWER PAK PLUS is connected to your vehicles battery the below indications may be experienced or buttons
used when needed.
•
GREEN LED Illuminated (Correct Connection LED): Indicating that the jumper cable connections are correct and the
circuit is working and ready for use, you can turn the engine ignition key to jump-start the vehicle.
•
RED LED Illuminated (Reverse Polarity LED) with buzzing: Indicating that the jumper cable connections are incorrect
(wrong) and buzzing to alarm the user to disconnect the battery clamps and re-correct the clamps correctly.
•
GREEN LED (Correct Connection LED) flashing with buzzing: Informing the user the vehicle battery is low, press the
“BOOST button, wait for the GREEN LED to illuminate then turn the engine ignition key within 30s.
•
NO LED’s Illuminated , No buzzing: Indicates the vehicle’s battery maybe damaged or the jumper cables may have a bad
connection to the vehicles battery terminals, Check the jumper cable connections to confirm a positive connection then,
press the “BOOST” button, wait for the GREEN LED to illuminate.Then you can turn the engine ignition key to jump-start
the vehicle.
POWER PAK PLUS Jump Starter Operation
1.
Press the ON/OFF/TEST button (9) and ensure that the POWER PAK PLUS battery charge LED indicators (5) are
illuminated with a minimum 3 BLUE LED’s.
2.
Connect the BLUE connector plug located on the end of the INTELLI-CHECK jumper cable (14) into the
jump start cable port (4).
3.
Ensure that the BLUE connector plug is firmly pushed into the jump starter cable port (4) for a positive connection and
ensure that the LED’s on the INTELLI-CHECK jumper cable (14) are NOT illuminated.
Note: Failing to securely locate the BLUE connector plug could result in a reduced electrical contact causing the plug to
melt or deform.
4.
Connect the POWER PAK PLUS INTELLI-CHECK jumper cable clamps to the vehicles battery terminals correctly, connect
the positive battery clamp (+ RED) (12) to the positive terminal (+ RED) of your vehicles battery and the negative battery
clamp (- BLACK) (13) to the negative terminal (- BLACK) of your vehicles battery
5.
Turn your ignition key to start the vehicle.
Note: If your vehicle does not start wait for approx. 10 seconds and repeat steps 1-5.
6.
When the vehicle has started, disconnect the POWER PAK PLUS jump starter clamps from the vehicle battery within 30
Seconds, starting with the negative battery clamp (- BLACK) (13) first and then the positive battery clamp (+ RED) (12).
7.
After disconnecting the POWER PAK PLUS jumper cables (12) & (13), leave the vehicle’s engine running to recharge
the battery.
Caution: Do not leave your vehicle unattended at any time.
14
4
12
12
12
13
13
13
13
12
19
18
20
Bipp Bipp
Bipp Bipp
